A Few Words
About the App
G3Link facilitates the control of GrandMA3 consoles. It utilizes the well-known OSC commands, which are sent and received bidirectionally across the network. The app interacts with the console and shows feedback, for example, the connection status and whether Highlight is active. Furthermore, presets can be synchronized and recalled.
New Possibilities
Features
01
Numbers Tab
Quickly check your fixtures with all the needed keys at your fingertips, including Next, Down, Highlight, Solo, and many others.
02
Groups
By syncing your groups, you can select the necessary fixtures much faster than selecting each one individually.
03
Attributes
Control all essential attributes including Dimmer, Position, Color, Focus, Zoom, and Shapers. Within Shapers, switch the mode to manipulate 1A and 1Rot or 1A and 1B blades.
04
Easy Config
In GrandMA3, set the OCS Name to “RemoteApp” and enable “Receive” and “Send Command”. Enter the console IP on the app’s config page, and you’re ready to go!
05
Feedback
You’ll receive feedback in the app to see the selected fixtures and the status of Highlight (active or inactive).
06
Commands
With the command input field, you can type any command, mirroring the direct input on the console.
Set Up
1. Network Connection
Ensure this device is on the same network as the grandMA3 Console/OnPC you want to control.
2. grandMA3 OSC Settings
Open the grandMA3 application and navigate to “Menu” → “In & Out” → “OSC“.
Preferred IP: This is the preferred address range used by the OSC protocol.
Interface: Select the desired network interface.
Enable Output → active
Enable Input → active
3. Configure OSC Data
Either use an existing configuration or insert a new one by selecting Insert New OSC Data.
Name = “RemoteApp” (case-sensitive)
Destination IP: Either the IP of the RemoteApp Device, or the Broadcast IP. This can also be set later, similar to the G3Link App.
Mode = UDP
Port = 8081 (Default from G3Link) or choose your own.
Prefix = grandMA3 (case-sensitive)
Receive Command = Yes
Send Command = Yes
Leave all other settings as Default.
4. G3Link App Configuration
In the G3Link App, navigate to the furthest right tab:
Config.
IP-Address: Set the IP Address of the grandMA3 Console or OnPC.
Port: 8081 (Default from G3Link) or the one configured on the grandMA3.
Select Connect
Once connected (the dot in the top right corner will turn green), your device’s IP can be transmitted to the Console if not already set manually.
5. Sync Settings
The number of groups and presets to synchronize can be defined here.
Our Users Love Us
Reviews &
Ratings
11 Dec / Renee Sims
3 Dec / Johnny Simpson
27 Nov / Calla Wang
” Nullam ac urna eu felis dapibus condimentum sit amet a augue. Sed non neque elit. Sed ut imperdiet nisi. Proin condimentum. “